AVCesar

Code: Select all

It should be automatically region free.  But to set the Blu-ray region to A, B or C, please do the following:

 - Turn on the player without any disc inserted.  After awhile, the screen with show "NO DISC".
 - About 2 seconds after the "NO DISC" is displayed, press DIMMER, DIMMER, DIMMER, MUTE and then the region code.
     1 for Zone A
     2 for Zone B
     3 for Zone C.
 - Power off your player.  When started up again, the region code has changed.

The region code selection must be done within 20 seconds.
You player's firmware must be the BDP9x-42-0323 release or newer.

To select a specific DVD region, press DIMMER, DIMMER, DIMMER, PURE AUDIO, X, where X is the DVD region 0 to 6.  Default is 0 (all regions / region-free).

Code: Select all

By default, your bluray player is region free for DVD. To set the bluray region to A, B or C, please do the following:
1. Power on the player without any disc inserted. The screen will after a while show “No Disc”.
2. About 4 seconds after the “No Disc” displayed, press DIMMER, DIMMER, DIMMER, MUTE and then the region code. 1 for A, 2 for B, and 3 for C.

3. Power off your player. When started up again, the regioncode has changed.
Selecting the region code on the remote, must be done within 20 seconds.